Wood Movement Identification
|
Terry & Clark 8 day pull up
Note: Four slots in the seat board for the weight and pull up cords, coil
hammer, one single wrought iron bell stand off of middle plate post.
Silas Hoadley 30 hour
Note ; Three plate posts, two end ones fit onto the dial, two split dowels
rest on top of seat board acting a spreader for when the pine seat board
would shrink. Also on the minute post end there is a threaded brass tip
with hole for taper pin to hold the minute hand. Escape wheel was spoked.
KDR 8 day key wind
Note: Figure 8 weight cord slot holes in the seat board. The verge can be
removed out the rear from the brass pendulum rod hanger. This mvt. also
would have the Hoadley style calendar. Weights run on a compounded
system.
Hopkins (Litchfield Conn.)
Note: The lifting arbor is wood and on the outside of the front plate.
The winding drums is threaded where the cord winds.
Joshua Stanton, Kent, Connecticut
|
This thirty hour mvt. is similar to a Eli Terry made C. 1800 - 1805. Points of
interest this Mvt. has a wood calendar wheel, the dovetailed rear plate is
pinned (not screwed ) to the seat board, has a noticeable smaller first wheel
time, the dial resting place on the seat board is shelf like (not slotted) and
the plate post turnings are not fancy.